Spray Elastomers
Intellathane 520HP - Good Looking, Yet Tough
In areas where high humidity is a factor, most high-pressure (1:1) hybrids fail by pin-holing, blowing or delaminating. Our Intellathane 520 HP high pressure system is much less susceptible, due to its high polyurea/urethane ratio. Arnco's hybrids allow price conscious applicators to produce films without processing concerns. It's the smart choice for providing a cost-effective coating. The high-build film is crisp in appearance, while exhibiting excellent tensile/tear strength and balanced elongation.
High-Pressure Spray Competitive Comparison
| Physical Properties | ARNCO | Competitor A |
|---|---|---|
| Hardness (Sh) | 90A & 95A | 90A |
| Tensile (psi) | 2400 & 2500 | 2400 |
| Elongation (%) | 310 & 290 | 245 |
| Tear (pli) | 350 & 380 | 285 |
| Gel Time (sec) | 7 & 5 | 2-3 |
Intellathane 530
Our 100% polyurea systems offer security when producing coatings in highly humid or low temperature environments, and/or wherever moisture is inherently trapped within the substrate.
High-Pressure Polyurea Spray Competitive Comparison
| Properties | ARNCO | Competitors A & B | |
|---|---|---|---|
| Hardness (Sh) | 85A & 90A | 85A | 90A |
| Tensile (psi) | 3100 & 2500 | 2500 | 2500 |
| Elongation (%) | 720 & 300 | 720 | 265 |
| Tear (pli) | 580 & 480 | 430 | 400 |
| Gel Time (sec) | 12 & 5 | 6 | 2 |